Intercom: Audio, Video Intercom Systems  (2,665)

Allows multiple buildings to communicate across a single, logical network Allows up to 480 Entrances, 96 Guard Stations, and 5,000 tenants

Provides selective door release capability Compatible with JP, JF, and KB Series Both normally open and normally closed output options

Video Adaptor for CCTV Camera and Audio Door Station Allows CCTV camera to be viewed on AX Series video master station Standard motion detector used to auto-activate camera Audio door station can be used for communication to camera location Relay output to trigger external device when CCTV camera is activated Video output for connection to standard CCTV monitor or recorder for full time video signal Sensor input to trigger CCTV automatically Video output allows constant viewing of CCTV camera

Page from an intercom master station through PA system Takes the place of a separate microphone for paging where there is an intercom School uses: page hallways, playground areas, cafeteria, etc. Medical facilities and/or office uses: page waiting areas, hallways, break rooms, etc.

Aiphone PC-359B is a call holding circuit board that provides latching function when call is placed from a speaker and N/O call button.

Allows two master stations to answer a single door station Combined use with RY-AC/A for external signaling

Weather resistant Vandal resistant Inside space for cabling Mounts to flat wall surface

12

Aiphone AMP-LE-F/2 is a 2 button stainless steel door station for use with the various Aiphone audio intercom systems.

Aiphone C2-PE-200 is a polyethelyn cable of 200 metres.

4 core 0.9mm diameter solid copper, polyethylene insulation 100m.

6 core, 9mm diameter solid conductor three pair polyethylene cable, 100 metre roll.

Aiphone CVFS-1  is a flush mount 1 button panel with MK-DAC pan and tilt.

Stainless steel construction One conduit knockout on the bottom side One or two-gang mounting hole pattern Built-in rain hood

Vandal-resistant with 16-gauge stainless steel construction Flexible design can be mounted to either side of the door 1-gang hole pattern allows for easy installation

Flexible design can overhang mullion on either side of the door Wire cutouts allow for installation when there is an external conduit Clearance for Cat-5/6 cables prevents overbending

Allows desk mounting of master and/or handset station Station is propped up for easier viewing Pre-drilled mounting holes Constructed with sturdy ABS plastic Adjustable to 45° or 60° angles

Steel construction Mounts to a door mullion of a glass entry Weather resistant for outdoor use Mounts door station at 45° angle Mounts any 1-gang surface mount Aiphone Audio-only or Audio Video Door Station

Made of 12 gauge stainless steel Fully enclosed beacon/strobe light on top Emergency Lettering ADA Compliant: 4″ depth to meet ADA requirements to allow mounting higher than 27″, and proper signage and call button mounting height

Made of 12 gauge stainless steel Fully enclosed beacon/strobe light on top Assistance Lettering ADA Compliant: 4″ depth to meet ADA requirements to allow mounting higher than 27″, and proper signage and call button mounting height

Made of 12 gauge stainless steel Caged beacon/strobe light on top Assistance Lettering ADA Compliant: 4″ depth to meet ADA requirements to allow mounting higher than 27″, and proper signage and call button mounting height

UL-514-A listed electrical box included at the base Access panel at the rear base of the tower EMERGENCY signage Beacon/Strobe is always lit; flashes during emergency call-in (Requires 24V DC) Weather and vandal resistant LED for station illumination in station over-hang (requires 24V DC) Call button mounting height and signage meets ADA regulations

Emergency call from tenant station to GT-MK(B) Pull Cord Switch suitable for wet locations Normally Closed mechanically latching switch rating of 24 VDC at 500mA May be actuated by pulling on nylon cord or by pulling down the red actuator

Aiphone GT-VP is a vandal resistant panel for GT-VB camera module.

Aiphone GF-AP is a vandal resistant panel for GT-AD address module.

Aiphone GF-BP is a vandal resistant blank panel to cover open module space on GT Series entrance station.

Aiphone GF-3P is a 3-call button panel for GT-SW.

Aiphone GT-104HB is a vandal resistant 1x4-module hooded surface mount box for GT Series entrance panel.

Aiphone GF-3F is a vandal resistant 3-module front frame.

Aiphone GT-OP2 is a 2-module postal lock with frame.

Aiphone GT-OP3 is a 3-module postal lock with frame.

4-way video distribution adaptor Tenant station trunk line adaptor, up to 4 stations

Used to call up elevator to specific floor Programmable for desired functionality 20 relay outputs Operating time from 1 second to 600 seconds

Long distance adaptor for up to 980’ to door CCTV camera adaptor with audio door station

Wiring hub for AX system using Cat-5e Two 24V DC power supply input terminals Rack mountable Controls all functionality of AX system Two BNC composite video outputs and video switching triggers CO line transfer (requires Viking K-1900-5 programmable auto-dialer) Programmable functionality via supplied software

Wiring hub for AX Series system using Cat-5e Two 24V DC power supply input terminals Rack mountable

Weather resistant Vandal resistant Inside space for cabling Mounts to flat wall surface Opening at bottom for drainage

Stainless steel surface mount box for card reader door stations Weather resistant Vandal resistant Inside space for cabling Mounts to flat wall surface Opening at bottom for drainage

A surface mount box for Aiphone's KB-DAR and KC-DAR colour video door stations Stainless steel construction Weather resistant for outdoor use

Aiphone C2-PE-100 is a polyethelyn cable of 100 metres.